Statement Of Use; Technical Data; Operating Mode - Desoutter RFD-100-140 Manual De Instrucciones

359893_09
Original instructions.
© Copyright 2015, Desoutter HP2 7SJ UK
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.

STATEMENT OF USE

This product is designed for drilling or tapping
holes.
No other use is permitted.
For professional use only.

TECHNICAL DATA

● See table page 3.
Noise and vibration declaration statement
Noise level 88 dBA
(+ uncertainty
of 3 dBA)
Sound level 99 dBA
(+ uncertainty
of 3 dBA)
Vibration level < 2.5 m/s²
All values are current as of the date of this
publication. For the latest information please visit
www.desouttertools.com.
These declared values were obtained by
laboratory type testing in accordance with the
stated standards and are suitable for comparison
with the declared values of other tools tested
in accordance with the same standards. These
declared values are not adequate for use in risk
assessments and values measured in individual
work places may be higher. The actual exposure
values and risk of harm experienced by an
individual user are unique and depend upon
the way the user works, the workpiece and the
workstation design, as well as upon the exposure
time and the physical condition of the user.
We, Desoutter, cannot be held liable for the
consequences of using the declared values,
instead of values reflecting the actual exposure,
in an individual risk assessment in a work place
situation over which we have no control.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
An EU guide to managing hand-arm vibration can
be found by accessing http://www.pneurop.eu/
index.php and selecting 'Tools' then 'Legislation'.
We recommend a programme of health
surveillance to detect early symptoms which
may relate to noise or vibration exposure, so that
management procedures can be modified to help
prevent future impairment.
INSTALLATION
● See figure 1 page 3.
following EN

OPERATING MODE

ISO 15744
following EN
ISO 15744
following EN
ISO 20643
6 / 36
English
A water free and filtered air supply
is required at a pressure of 6.3 bar
(91.4 psig) with a flow rate of 9.9 l/s
(21 cu.ft/min) controlled by a pressure
regulator selected from Desoutter Air
Line Service Equipment Catalogue.
● Contact your local Desoutter
representative for more information.
● Always disconnect the tool from the
air supply before attempting any
replacement, adjusting, servicing or
dismantling.
● Ensure that no loose articles or
clothing, loose hair or cleaning
material can be caught by the moving
parts of the tool.
● Always allow the tool to stop before
removing the work.
● Ensure that the work piece
is securely clamped before
commencement of operation.
Eye and ear protection must be worn
when operating the tool.
● Do not operate the tool in explosive
atmospheres.
When machining hazardous materials,
provision must be made for dust
collection or suppression.
Power tools are not insulated against
coming into with electric power.
● Keep your fingers away from the
rotating drive at the aperture for
ejection of swarf. You can be cut or
burned if you come into contact with
the drill bit, chips or the work surface.
● Do not start the tool if the slot is not
hidden by guard or vacuum.
07/2019