IntesisHome
®
PA-AW-WIFI-1
®
4. IntesisHome
device installation procedure
Installation process should
only be performed by an
authorized installer
Important: Use only the cable attached. Extending or shortening the connecting cable included
with the interface may cause it to malfunction. Keep the connecting cable as far away as possible
from electrical wires and ground wire. Do not bundle them together.
If you have an Aquarea Bibloc model, please see section 4.1. On the other hand, if you have an Aquarea
Monobloc model, please move to section 4.2.
4.1 Connection to Bibloc Aquarea indoor unit
1. Unplug the Aquarea system from the power supply line.
2. Detach Control Panel's cable from the Indoor Unit Electronic Controller Board (CN-Remote
connector, see Figure 3). Please see the document at http://www.intesishome.com/docs/PA-AW-
WIFI-1-Aquarea-Install.pdf
3. Open the top lid of the IntesisHome
4. Remove the top hole IntesisHome
5. Connect Panasonic's Control Panel cable
in the IntesisHome
Insert the cable through the IntesisHome®
top hole for cable use to correctly set the
connection cable.
Use the cable holes on the bottom of the
Indoor Unit to pass the cables through
(see Figure 3).
6. Connect one end of the IntesisHome
Device cable, supplied in this package,
in the K1 connector of the IntesisHome®
Device itself and the other end into the
Indoor Unit as if it was Panasonic's Control
Panel cable (CN-Remote connector).
Insert the cable through the IntesisHome
top hole cable to correctly set the
connection cable (see Figure 3).
7. Close the IntesisHome
8. Plug the Aquarea system to the power
supply line.
4
®
device.
®
cable cover (see Figure 1)
®
Device K2 connector.
®
®
®
lid again.
INSTALLATION GUIDE
Important:
Please
Instructions provided by the Panasonic
service manual and/or installation manual.
CN-Remote
connector
Indoor Unit
®
IntesisHome
cable
Panasonic
cable
Figure 3.- IntesisHome
Bibloc connection diagram
follow
all
Safety
®
IntesisHome
device
To K1
To K2
connector
connector
®
Device and Aquarea