Maintenance And Care - Go Rhino RC3 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
INJURY HAZARD
Please complete a shop and tool inspection prior to beginning the installation.
• Always make sure you have a clean, dry and well lit work area.
• Always remove jewelry, loose fitting clothing and wear protective gloves and eye protection.
• Always use extreme caution when jacking or raising a vehicle for work. Set the emergency
brake and use tire/wheel blocks and jack stands. Refer to the vehicle manufacturer hand
book. Utilize the vehicle manufacturers designated lifting points.
• Always use appropriate and adequate care in lifting parts during disassembly and
installation. Seek help in lifting heavy or large items into place. Utilize jacks and or lifting
devices when available.
• Always insure products are secure during disassembly and installation.
• Always wear eye protection and take steps to protect any exposed skin during the
installations. Drilling, cutting and grinding plastic and metal may create flying particles that
can cause injury.
• Always use extreme caution when drilling, cutting and or grinding on a vehicle. Thoroughly
inspect the area to be drilled, on both sides of material, prior to modification and relocate any
objects that may become damaged.
• Always assemble and tighten all fasteners per the installation instructions.
• Always route electrical cables carefully. Avoid moving parts, parts that may become hot and
rough or sharp edges.
• Always insulate and protect all exposed wiring and electrical connections.

MAINTENANCE AND CARE

• Always perform regular inspections and maintenance on mounts and related fasteners.
• Periodically check and tighten all fasteners.
• Stripped, fractured, or bent fasteners must be replaced.
• After washing the vehicle make sure to fully dry all surfaces.
• In areas with cold temperatures make sure to wash the product often to remove harmful
materials used on road ways.
• Never use abrasive cleaners or polish compounds. Clean with a gentle soap and water. If you
use wax use a non-abrasive automotive wax such as pure carnauba wax.
WARNING
Some products have been designed to work together with factory rear sensor systems, factory forward
facing sensor systems and factory air bags.
Installation of some of these products may alter the factory sensor system performance.
•
Factory sensors may read shackles or hooks protruding from the fairlead and or tow hooks.
•
All sensor testing is completed by Go Rhino Products and or third party testing labs on modified
•
vehicles.
• Sensor sensitivity, factory sensor housing, orientation, and operating conditions are all variables that
will influence functionality of the sensors.
Installation of some product may effect the factory air bag systems.
•
Some products allow the use of third party products such as winches, shackles, hooks, etc. Follow the
•
respective manufacturers operating instructions for use with our products.
• Make sure to fully understand the product, it's intended use and operation prior to use.
Above all... be safe!
•
REV.01
© 2016 Go Rhino Products. All rights reserved
8