Installation Guide; Electrical Connection; Fitted Unit; Installing The Appliance - Blaupunkt 5WS 16400 Manual De Uso

Installation guide

Electrical connection

The appliance may only be connected to an earthed socket installed in accordance with the regulations.
Replacement of the connection cable or relocation of the socket must only be carried out by a qualified
technician or expert in accordance with the current legislation.
The appliance may only be connected to the mains using the connection cable
supplied.
The use of multiple sockets, socket strips (distribution boards) or extension cables is not permitted.
Overloading may cause a fire.
If the plug can no longer be reached after the appliance is installed, the electrical connection must be
made using an all-pole switch suitable for the current strength. This switch must have a minimum
distance of 3 mm between the contacts, so that interruption is possible in an emergency.
The connection must be fitted with appropriate earthing according to current regulations.
The appliance must not be used unless it is properly earthed.

Fitted unit

The appliance cabinet or fitted cupboard must have a fixed intermediate shelf and must not have a rear
wall.
There must be a gap of at least 2 cm between the building wall and the intermediate shelf. This gap is
necessary to prevent a build-up of heat.
If used in combination with other appliances, please follow the installation instructions for
combinations.

Installing the appliance

Place the appliance on the intermediate shelf in the unit and push it in until the mounting brackets on the
left and right of the device are flush with the unit.
Make sure the appliance is level and located centrally in the unit. The gaps between the appliance and the
unit on the left and right must be the same size. The appliance must not come into direct contact with the
wood on one or both sides.
Fix the appliance in the unit using the screws supplied.
During installation, make sure the drawer is not tilted out of the unit before the appliance is screwed to the
unit at all the screw locations.
Take care to avoid bending, clamping or damaging the connection cable during installation. The
connection cable must not touch the appliance after installation.
11