Cleaning The Hob, Burners And Accessories - Angelo Po 1N1FAGV Manual De Uso

– Rinse surfaces with drinking water and dry.
– Pressurised water jets may only be used on
external parts.
– Take special care not to damage stainless steel
surfaces. In particular, avoid the use of corrosi-
ve products and do not use abrasive materials
or sharp tools.

CLEANING THE HOB, BURNERS AND ACCESSORIES

Avoid leaving the components dirty for long
and, periodically,according to the intensity of
work (if necessary daily),proceed as indicated
below:
Switch the appliance off and leave it to cool.
1)
Remove the grill, the burner cap (A) and the
2)
burner (B).
Put them to soak in hot water with dishwash-
3)
er soap.
Wash with a normal sponge and if necessary a
4)
scourer to remove any dirt thoroughly.
Check that the holes of the burner cap (A) are
5)
always completely clear for the regular fl ow of
gas. To remove possible dirt, insert a metal rod
(wire) into the hole and slide it through until it
is thoroughly clean.
Check the burner (B) ignition slot (cutoff ) is
6)
always completely clear for the normal fl ow
of gas. To remove any dirt, insert a blade like
a trimming knife in the slot, sliding it around
until it is thoroughly clean.
Carefully clean all the connecting parts
7)
between the burner cap (A) and the burner
(B). If necessary use a steel wire brush for
mechanics.
Clean every part of the hob with a suitable
8)
de-greaser.
Dry the surfaces and reassemble the parts.
9)
For the correct assembly of the burner (B) and
burner cap (A), follow the directions given in
the illustration.
3319990_ut_rev.2_GB
– Remove food residues immediately before
they set.
– Remove the limescale deposits which may
form on some of the appliance's surfaces.
Turn on the burners for a few minutes to
10)
ensure a thorough drying and thus avoiding
the formation of rust.
Cautela - Avvertenza
Caution - Warning
Do not wash cast iron parts such as the burn-
ers, burner caps and grills in a dishwasher.
Caution - Warning
Never pour water or allow dirt to fall into the
burner as this will cause the burner to mal-
function or block the nozzle.
- 13 -
A
B
GB GB
ENGLISH