Installation Procedure - IntesisHome PA-RC2-WIFI-1 Guia De Instalacion

IntesisHome PA-RC2-WIFI-1
®

2. Installation procedure

Installation process should only be performed by an
authorized installer.
Please follow all Safety Instructions provided by the Panasonic service manual and/or installation
manual.
There are two installation options available: With Control Panel and without Control Panel.
2.1 With Control Panel (Recommended)
This method assumes that you want to control the Panasonic system both with IntesisHome and the
Panasonic Control Panel.
1. Unplug the Panasonic system from mains electricity.
2. Open the top lid of the IntesisHome device.
3. Remove IntesisHome's Top Hole cover.
4. Connect one end of Panasonic's bus cable into IntesisHome device K1 connector.
5. Connect the other end of Panasonic's bus cable into Panasonic's Indoor Unit R1R2 connector or
Remote Control Wiring (see www.intesishome.com/docs/PA-RC2-WIFI-1-Install_sketch.pdf for
more information).
6. Connect another cable from Panasonic's Control Panel connector to Panasonic's Indoor Unit
R1R2 connector or Remote Control Wiring (see www.intesishome.com/docs/PA-RC2-WIFI-1-
Install_sketch.pdf for more information).
Wi-Fi Router or
Access Point
4
3 m
K1
INSTALLATION GUIDE
R1
# 1
R2
. . .
R1
# n
R2