Stylies TITAN ULTRASCHALL Instrucciones De Uso página 20

FIRST USE / OPERATION
Please note: never transport the device with a full water tank.
Possible hazards:
too much water from water tank comes into the Main Base (17), this overloaded water level
•
will cause dramatic reduction of mist output of the device.
water can easily come out from the Main Base (17).
•
the water tank can fall off from the Main Base (17) and get damaged due to the heavy weight
•
from the water (and water can leak on to the floor).
1. For this reason, Main Base (17) of the Stylies TITAN humidifier should be placed first with
empty Water Tank ( 16 ) in a suitable location.
2. When the device is in the desired location: Fill Water Tank ( 16 ) with fresh water and
screw the Tank Cover (19) back on firmly and check that it is sealed properly. Place Water
Tank on base.
3. Plug Power Cable into the power socket. Switch on the device by pressing the On/Off switch
on the Control Panel (3), the display lights up white.
Caution : If the red «Low water» warning
Check if the water tank is full. If so, it may take several minutes to refill the water collector
(24) if necessary (the red light
4. The Mist outlet (1) can be turned 360°. Never point the outlet at walls or furniture, etc. Don't
point the mist outlet toward the cable, otherwise the hygrostat can't measure the relative room
air humidity properly. The Display panel (7) shows the current relative air humidity in the
room, e.g. «36 % RH».
Select the desired air humidity level by pressing the humidity button
5.
and adjusting with the
humidity. «Co» means continuous operation without automatic control. We recommend
40-60 % rel. air humidity for living areas.
When the display (7) stops flashing, the setting has been saved and the current air humidity is
displayed again. The humidifier starts automatically as soon as the humidity is lower than the
setting, and stops when it is higher. During humidification the lamp
display lights up.
Note : If «Co» (continuous operation) is set, the humidifier WILL NOT STOP OR START automati-
cally. To avoid excessive humidity, use «Co» for a short time only.
Set the mist quantity in three stages by pressing
6.
7. The display lights up as soon as any button is pressed, and goes dark 15 seconds after-
wards. The air humidity is displayed even when switched off (to prevent this, pull out the pow-
er plug).
8. Press the timer key
just the shutdown time in hours with the
9. «Low water» warning: this red LED
case turn off the «On/Off» power switch
tank in the base and turn the power on again.
Note: When you remove the tank, some water can flow out of the descaler cartridge.
To prevent damage, always turn off the power when the «Low water» warning lights up.
lights up, the humidifier cannot be switched on.
then goes out).
and buttons. Settings are in 5% stages from 40 % to 75 % rel. air
to activate the automatic shutdown time (display flashes «1H»). Ad-
, lights up if the water collector is empty or too low. In this
and fill the tank with fresh water. Then replace the
and (1 = low, 3 = high).
and keys (1-12 hours or «–-- H» for no timer).
on the Control Panel
on the left of the humidity
17