Installation; How To Install - Kenmore 580.74121 Manual Del Propietário

INSTALLATION
Pick a location which will allow you to blow the cold
air into the area you want. Windows used for
installation must be strong enough to support the
weight of the air conditioner, Good installation with
special attention to the proper position of the unit
will lessen the chance that service will be needed,
When cooling more than one room, installation
location is very important. If air conditioner is
blocked by a storm window frame, see step 19 on
page 8 before beginning to install. To cool your
rooms, cold air must be blown from the air
conditioner in a straight path.
HOW TO INSTALL
_1 Remove the screws which fasten the cabinet at
both sides and at the back. Save side screws.
Discard back screws.
M Insed the side curtain (ITEM A) intothe upper
guide and lower guide of the air conditioner. Fasten
the curtainsto the unitwith screws (ITEM E).
IL_ open the window. Mark a line on center of the
window inner sill. Carefully place the cabinet on the
window inner sill and align the center of the cabinet
front with the center line marked in the window inner
sill.
Windowsill
FIG. 7
FIG. 3
_ Slide the unit out of the cabinet by gripping the
base pan handle and pull forward while bracing the
cabinet.
FIG. 4
IV"! Cut the FOAM STRIP (ITEM I) to fit the
underside of the window sash. Peel off the backing
and attach the FOAM STRIP as shown in Fig. 5.
r_Pull the bottom window sash down behind the
upper guide until they meet.
NOTE: Do not pull the window sash down so tightly
that the movement of side curtain is restricted.
Form st_
_'-_ Loosely assemble the sill supports using the
parts in FIG. 9.
FIG. 5
.DO.OR 0 O0 OOR
_-_" ITEMDITEMB
ITEMC
FIG. 9
-6-