Rest Heat; Features - Verona VECTIM365 Manual De Uso Y Cuidado

A beep confirms that the new value was accepted
correctly.
To cancel the timer, hold [T-] key until the value decrease
to "00" or touch both [T-] and [T+] simultaneously in
order to reset the value to "00" rapidly.
In some models the timer can be set in relation with a
cooking zone:
• Select the cooking zone you want to time.
• Touch [T-] or [T+], the timer led related to the zone
starts flashing.
• Set the timer value.
• The timer led gets steady, the value is accepted and
the countdown begins.
If more than one timer is set, the display shows the
lowest value, the one that will expire first. The timer led
(ref.4) related to the zone which the displayed value is
referring to, is flashing. If the displayed value refers to
the independent timer, the timer led (ref.2) flashes.
Figure. 10
To check the remaining time for any one of the timed
zone, touch the [ON] key related to the zone: the
corresponding timer led will begin to flash and the value
on the timer display will switch for some seconds to the
new value. After a time-out, it will switch back to the
shortest one.
To check the independent timer value when it's not
displayed with the highest priority, touch [T-] or [T+] when
no zones are selected. The timer led (ref.4) flashes and
the displayed value switches to the independent timer.
When the timer value elapses:
• An end of activity beep sequence sounds: three short
beeps followed by a long interval are repeated for 1
minute.
• The led indicator related to the elapsed timer flashes.
• The timer value "00" flashes too and will continue to
flash waiting for a user confirmation.
• Touch [T-] or [T+] to cancel the expired timer, the
display switches to the next shortest timer or gets
blank if there aren't any other timer set.
12
4
WARNING: the timer is only intended as an acoustic
advisor that recalls the attention of the user.
Timers have no effect on the heating elements. The
cooking zone must always be stopped manually by
touching the related [OFF] key.

Rest Heat

The HOT SURFACE indicators remain on even after
the end of the cooking activity, just the necessary time
to let the surface cool down below a safety value.
Figure. 11
The residual heat time depends on the power level that
was set on the cooking zone and the time the heating
element has been working for.
For example, a cooking zone that has been working for
more than 5 minutes at full power will take half an hour
to cool down before the Residual Heat indication fades
away. At level 1 it will take about 10 minutes.

Features

The control is checking its own ambient temperature
and stops any activity in case of overheating of inner
parts. Let the appliance cool down.
Use & Care Manual
ENGLISH