Publicidad
Idiomas disponibles
Idiomas disponibles
TO REMOVE DUST BAG
TO REPLACE DUST BAG
•
WARNING
Always unplug power cord from
electrical outlet before performing
any service on vacuum.
Pull out on the
bag cover
release located
near the top of
the bag cover.
Bag Cover
Release--__
Bag
/!1t
C°ver_7_
Grasp the dust bag
collar and pull gen-
tly, carefully remov-
ing the dust bag,
Throw away the
used dust bag.
Do not reuse.
Pull the bag
cover forward
and lift up,
Remove and
lay aside.
Bag
BagHolder Check the bag
holder and the
cavity motor safety fil-
ter. If either is
blocked, check
safety
TROUBLE-
Filter
SHOOTING.
CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet
freshener, face powder, fine dust,
plaster, soot, etc. can clog the bag
and cause it to burst before it is
full. Change bag more often when
vacuuming these materials.
Unfold the
newdust
bag_
oust
Bag
Fold the safety
seal tab on the
new dust bag
away from the
//
opening that
Y
fits on the bag
holder,
Seal Tab
NOTE: See PARTS AND FEATURES for
Bag number,
Insert the dust bag
onto the bag holder
completely by holding
the bag collar,
Tuck the bag
behind each of
the four bag
retention corner
flaps shown here,
Be sure the bot-
tom and sides of
the dust bag are
completely within
bag cavity prior to
replacing the bag
cover.
Place the dust bag
collar into position.
Retention
Slots_
Close the bag
cover.
Position the bag
cover so its
positioning tabs
fit into the body
positioning tab
slots.
You will hear a
distinct snap
when cover is
securely closed.
Bag
Check to see
AL_II
/ !
that the dust
bag is fully enclosed in the bag cover.
14
Publicidad
