Important Warning; Iinstallation - Jilong CHEYENNE V Serie Manual De Instrucciones

IMPORTANT WARNING

To enhance the enjoyment of your boat and protect the safety of the operator using
the product, ALWAYS STRICTLY OBSERVE the following important safety points.
These should be read and understood prior to use:
1.WARNING: This is not a life saving device. Use only under competent
supervision. Never allow diving or jumping into this product. Never leave in or near
the water when not in use. Never tow from any other craft. Adult assembly and
operation required.
2.WARNING: Inflating the product's chambers should be as the numbered
sequence and do not over inflate. Excessive inflation of the product can cause
the chambers to burst or cause damage to the welded seams.Not following
the operator's instructions, which may detail important inflation and assembly
sequences,can cause capsizing and drowning.
3.WARNING: It is highly recommended that a user should take a boating safety
course and get hands-on training from your boat dealer or local boating authorities.
Review all safety requirements regularly. Never navigate alone.
4.WARNING: A Personal Flotation Device (PFD) is required for each passenger. It
is especially important that children and non-swimmers wear a Personal Flotation
Device at all times. Children and non-swimmers need special instruction in the use
of Personal Flotation Device.
5.WARNING: Use caution when stepping or climbing aboard the boat Step into
the center of the boat for maximum stability. Distribute the weight of load and
accessories evenly so that the boat sits level fore to aft and side to side.Uneven
distribution of persons or loads in the boat can cause capsizing and drowning.
6.WARNING: Do not use your boat if you suspect a puncture or leak. It may be
unsafe.
7.WARNING: BEWARE OF OFFSHORE WINDS AND CURRENTS.
8.WARNING: The total number of persons and total weight shall not exceed the
information printed on the boat. Do not exceed the maximum recommended
capacities. Exceeding the data given on the capacity plate can cause capsizing and
drowning.
9.WARNING: It is the responsibility of the boat operator to identify and obey all local
and state laws pertaining to boat safety and required safety equipment. Please
consult your local authorities to ensure compliance.
10.Do not allow unattended children in the boat. Always make sure that at least
one responsible adult is supervising all children and those who do not know how to
swim AT ALL TIMES.
11.Always maintain the proper boat safety equipment in an easily accessible area in
your boat. Clearly post emergency phone numbers as well as safety advisories and
rules (such as "No Jumping or Diving").
12.Boat is designed to be storable, seasonal boat. If you live in a temperate area in
which the boat will not be in use all year-round, it is STRONGLY RECOMMENDED
that you deflate the boat and dry it thoroughly, and store it in a protected area for
the off-season. This will help extend your boat and prevent a safety hazard from
developing while the boat is not in use.
13.WARNING: Certain household cleaning solvents, chemicals and other liquids
(such as battery acid, oil and petrol) could damage the PVC fabric. In the event of
spill or mishandling, you should check for leaks and inspect for structural integrity.
14.Follow these rules to avoid drowning, paralysis or other serious injuries.
6 www.jilong.com CBV-13-GB
INSTALLATION
1. Find a flat area and make sure that the surface you have selected to set up the
boat is completely free of stones, sticks, sharp objects or other foreign debris.
2. Carefully unfold the boat, spreading out the tubes and floor to make them as
smooth as possible. NOTE: For ease of install, it is preferable to set up the boat
on a warm and sunny day. If time permits, expose the unrolled boat to direct
sunlight for 1 hour or more, so that the boat material will be more flexible during
installation.
CAUTION: DO NOT DRAG THE BOAT, AS IT MAY TEAR THE BOAT OR CAUSE
OTHER DAMAGE. We will not be held responsible for damage caused to the
boat due to mishandling or failure to follow these instructions.
3. Inflate the boat's chambers in numbered sequences (1) ,(2)and (3) then (4).
It is very important to follow the numbered sequence: failure to do it could result
in an improperly inflated boat. You can use a hand or foot operated air pump,
or a low pressure electric pump to inflate the boat. Do not use high-pressure air
compressors. Inflate each air chamber in number sequence until all chambers
are full. Warning: Do not over inflate in one time; it is harmful for the boat body.
And over inflation of the chambers can cause the boat to burst or cause damage
to the boat body's seams.
Please see the below illustration for the detailed inflated and deflated operation
for Built-in Safety Valve.
a) Inflation: Unscrew the Valve Cap A, Assemble the Inflation
Adaptor with the Inflating Mouth B, Air pressure Meter and the air pump (Please
see the below (1) detailed illustration!).
7
B
www.jilong.com CBV-13-GB