Cleaning Instructions; Spray Gun; Troubleshooting - Remus HVLP RHV100 Manual De Instrucciones

L0841 RHV100 03 08.qxd
THE SPRAY GUN MUST BE THOROUGHLY CLEANED IMMEDIATELY AFTER USE. IF THE PAINT DRIES
INSIDE THE GUN, CLEANING WILL BECOME MUCH MORE DIFFICULT AND MAY RENDER THE GUN
INOPERABLE. THIS IS NOT COVERED BY GUARANTEE.
G
Remove the gun container.
G
Pour any leftover paint into its container so that it can be used for the future.
G
Pour a quantity of the respective thinner into container, shake the spray gun lightly, reassemble the gun,
then spray this liquid through the gun. Repeat this until the thinner being sprayed is coming through with
no traces of paint.
G
Clean any traces of paint off the outside of the spray gun.
G
Clean the container Seal (18) inside the spray gun body.
PROBLEM
The paint drips on to the item
being sprayed
Paint is thin or irregular
No paint being produced
12/3/08 8:51 am Page 9

CLEANING INSTRUCTIONS

SPRAY GUN

TROUBLE SHOOTING
CAUSE
Paint too diluted
Paint volume too high
Moving too slowly
Spray gun trigger being held for too
long
Spray gun too close
Paint too diluted
Paint volume too low
Moving too fast
Spray gun clogged
Spray gun too far away
Paint too thick
Gun clogged
Pick up pipe clogged
Air hose split
Grainy paint
Container almost empty
Spray gun at an angle
9
ACTION REQUIRED
Add undiluted material
Reduce the paint flow by turning
Fluid Adjusting Screw (14)
Increase speed of application
Release trigger earlier
Increase the distance between gun
and workpiece
Add undiluted material
Increase the paint flow by turning
Fluid Adjusting Screw (14)
Reduce speed of application
Clean the gun
Reduce the distance between gun
and work piece
Add thinner
Clean the spray gun
Clean pick up pipe
Replace air hose
Filter the paint
Refill container
Ensure Paint Feed Tube (17) is
angled towards paint