Descargar Imprimir esta página

Lighting Instructions - RealFlame C539LP Riverside Manual Del Propietário

Publicidad

Idiomas disponibles

Idiomas disponibles

Using the Igniter
1. Read and understand all operating instructions before lighting.
2. Burner control knob must be in the OFF position.
3. Connect propane (LP) cylinder (see previous pages).
4. Slowly open valve on LP gas cylinder.
5. Push and hold igniter button to create sparks.
6. While holding the igniter button with one hand, use your other
hand to push and turn the control knob to the LIGHT position
to light the burner.
7. Keep Burner Control Knob pressed in for 15-30 seconds after
ignition.
8. If ignition does not occur in 30 seconds, turn control knob to the
OFF position and turn gas o at the source, wait 5 minutes until
gas has cleared and repeat lighting procedure.
to LOW setting. Observe flame, make sure all burner ports are
lit. Flame height should be no higher than 13 inches tall.
10. Adjust the flame to the desired height with the
control knob.
Using a Long Match or Lighter
1. Prior to lighting, use a shovel to move lava rocks for
access to the burner.
2. Wearing heat resistant gloves, position the burning
long match or burning butane lighter near the side of
the burner. DO NOT lean over the fire column while
lighting!
3. Turn control knob counterclockwise to LIGHT.
4. Remove long match/long butane lighter.
5. After lighting, use a shovel and heat resistant gloves
to carefully move the lava rocks back into their proper
position.
6. After lighting, rotate the Burner Control Knob counter
clockwise to LOW setting. Observe flame, make sure
all burner ports are lit. Flame height should be no
higher than 13 inches tall.
7. Adjust the flame to the desired height with the control
knob.
!
WARNING
If burner flame goes out during operation, immediately
turn the control knob OFF and let the gas clear a
minimum of 5 minutes before attempting to relight
the fire bowl.
Please refer to the trouble shooting pages for
additional support, beginning on page 16.

LIGHTING INSTRUCTIONS

!
WARNING
When using this method to light
your fire bowl use heat resistant
gloves and follow the step by step
instructions. Failure to do so could
result in severe injury.
12
Control Knob
PUSH
IN

Publicidad

loading