Bosch TS2000 Instrucciones De Funcionamiento Y Seguridad página 9

BM 2610013454 06-10.qxp:BM 2610013454 06-10.qxp 6/1/10 10:36 AM Page 9
For Mounting Other Table Saws to
Model TS2000
Important: Before mounting a DeWalt,
Craftsman, Makita, Hitachi, or Ridgid table
saw, insert two (2) 8mm x 50mm Phillips
head screws through "B*" hole locations and
tighten using 8mm lock nuts.
1. Using the diagram below, locate the
correct mounting holes for the table saw
being used and position saw on stand
accordingly.
For use with Hitachi Table Saw:
If your TS2000 stand does not have "H"
holes, you will need to drill holes. Place
the saw over the center of the opening and
make pencil marks (through the L-shaped
bracket holes) on the table top mounting
plates. Remove saw and drill four (4) 5/16"
diameter holes through the mounting
plates.
For use with Ridgid Table Saw:
Locate the four "R" holes in the two
mounting plates and drill four (4) 3/8"
diameter holes completely through the
stand's frame.
2. Mount the table saw using the appropriate
mounting hardware for your table saw
FIG. C
Table Saw Models model.
Bosch 4100/4000
Dewalt DW744
Craftsman 21830
Makita 2703
Hitachi C10RA2**
Ridgid TS2400LS**
**See instructions.
-9-
FIG. B
Mounting
Holes
B
D
C
M
H
R