Mounting Steps - Lenze L-force Drives E84AZESR5524LD Instrucciones Para El Montaje

5.2.2

Mounting steps

Proceed as follows for installation:
1. Prepare M5 threaded holes on the mounting plate and equip them with
screws and washers.
–
Two M5 screw and washer assemblies or M5 hexagon socket screws
with washers for the filter.
–
Two M5 screw and washer assemblies or M5 hexagon socket screws
with washers for the standard device.
–
Do not yet tighten the screws.
2. Remove the screw and washer assemblies from the filter to fix the
standard device.
3. Mount the filter onto the prepared mounting plate.
–
Only tighten the screws hand-tight.
4. Mount the standard device onto the prepared mounting plate.
–
Observe the instructions in the documentation for the standard device.
–
Only tighten the screws hand-tight.
5. If necessary, preassemble additional units.
6. Align all units.
7. Screw all units onto the mounting plate.
–
Tightening torque: 3.4 Nm (30 lb-in)
EDK84ZESR55 DE/EN/FR/ES/IT 2.0
Mechanical installation

Mounting variant
Mounting steps
5
E84ZESR021
41