Peg-Perego VIAGGIO1 DUO-FIX K TT Instrucciones De Uso página 30

height. There are 7 positions.
26• To change from a lower position to a higher one: pull
the tongue in the upper central part of the headrest
upwards. The headrest will move at the same time.
To change from a higher position to a lower one: pull
the tongue in the upper central part of the headrest
upwards and, at the same time, push the headrest
down to the desired position.
When you have finished, try moving the headrest
to check it is properly locked into place.
27• To determine the best shoulder strap position, bear in
mind that the child's shoulders must be just below the
shoulder strap guides.
28• IMPORTANT: The straps must not be too high or
too low with respect to the child's shoulders;
29• The Viaggio 1 Duo-Fix K TT car seat can be reclined into
5 positions.
To recline the seat, pull the lever under the seat (fig. a)
and adjust the seat to the desired position (fig. b).
Removing the soft cover
To remove the soft cover of the Viaggio 1 Duo-Fix K TT
car seat:
• Remove the booster cushion, where present (point 24).
• Unfasten the harness (point 17).
• Open the rear panel.
30• Unfasten the straps from the rear latch plate.
31• Unfasten the straps on the rear and slip them out from
the front.
32• Unfasten the shoulder pads from the rear and slip them
off the straps from the front.
33• Slip off the adjuster strap (fig. a) and then remove the
headrest from above (fig. b).
34• Release the crotch strap from below the body (fig. a)
and slide the strap out through the crotch strap cover
(fig. b).
35• Slip the strap out through the opening in the soft cover
and remove the soft cover, as shown in the figure.
Soft cover maintenance
Brush the fabric parts to remove dust.
• When washing, closely follow the instructions stated on
the label sewn into the cover.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
• Do not remove stains with solvents.
• Do not tumble dry.
Replacing the soft cover of Viaggio 1
Duo-Fix K TT
To replace the soft cover of the Viaggio 1 Duo-Fix K TT
car seat:
36• From below, slip the straps back in through the
opening in the fabric.
• Reinsert the crotch strap into the soft cover.
37• Fasten the crotch strap back onto the body.
38• Fasten the tongue to the crotch strap opening.
39• Put the soft cover in place, starting at the seat and
moving upwards, paying attention to the sides of the
backrest.
40• Slip the soft cover over the headrest, ensuring the red
tongue passes through the opening in the fabric.
• Slip the shoulder pads back onto the straps.
41• Insert the straps though the soft cover, starting with the
buckles.
42• Lengthen the straps and insert them through the body
of the car seat (the straps in the upper hole and the
buckles in the lower one).
43• Fasten them correctly on the rear, as shown in the
figure.
• Fasten the harness at the front (point 20).
IMPORTANT: the straps must not be twisted.
44• ATTENTION: The central adjustment strap must
pass between the body and the plastic shield, as
shown.
45• Open the rear panel and fasten the straps onto the rear
latch plate.
• For infants, reposition the booster cushion.
Accessories
46• Clima Cover Car Seat: washable cover in Tencel,
a natural heat-regulating fiber that regulates body
30
•
47
48
49
50
•
•
•
•
•
•
•
•
•
•
•
•