Troubleshooting - Sunbeam FlexFit Heated Wrap Manual De Instrucciones

TROUBLE SHOOTING
Problem Solution
No Heat / No Power • Verify tight connection between pad and
controller. If disconnected, to restart unit,
press the Control Button until the desired
heat setting is reached.
• Verify AC outlet is functional.
• Verify no physical damage to the cord,
controller or pad. If there is damage,
discontinue use.
• If failure continues, discontinue use. See
warranty information to contact Sunbeam
Consumer Service.
Pad has No Heat & • Auto-Off feature has been activated and
Controller 'Auto-Off'
set to turn the unit off after 2 hours of
Indicator is Flashing
continuous use.
• To re-start unit, press the Control Button
until the desired heat setting is reached.
Pad has a Hot Spot • Ensure the pad is not folded, bunched,
overlapped or crushed in any area.
'High' Heat Setting The 'High' Heat Setting Indicator light will start
Indicator Light is Flashing
flashing when a fault is detected. Follow these
steps to reset:
1. Unplug the controller from the AC outlet.
2. Verify tight connection between pad and
controller.
3. After 10 seconds, plug the controller in the
AC outlet.
4. Press the Control Button until the desired
heat setting is reached.
If flashing light persists, an error has occurred.
Discontinue use of the product and see warranty
information to contact Sunbeam Customer Service.
FlexFit 900_19ESM2 (US).indd 9-10
-
-9
FCC CERTIFIED
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This product has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This product generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this product does cause harmful interference
to radio or television reception, which can be determined by turning the
product off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and receiver.
• Connect the product into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
-10-
2/14/19 10:22 AM