Descargar Imprimir esta página

D-Link DHP-W220AV Guía De Instalación Rápida página 3

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
PRODUCT SETUP
HARDWARE INSTALLATION
Before you can configure your DHP-W220AV for use, make sure the location being extended is on
the same electrical circuit. The diagram below shows an example of a Powerline network:
ROOM A
Internet
ROOM A
HomePlug AV
Device
Internet
Modem
ROOM B
DHP-W220AV
Notebook
DHP-W220AV
Notebook
Your computer and DHP-W220AV are now connected. Please refer to "Setup Wizard" on the
next page to connect your DHP-W220AV with your existing Powerline network.
DHP-W220AV
ROOM B
HomePlug AV
Device
DHP-W220AV
Modem
Step 1
Make sure your existing HomePlug AV device is plugged into a
power outlet near your cable or DSL modem and connected to your
network.
Step 2
In the other room, plug your DHP-W220AV into a wall outlet in a
place you want to extend your network.
iPad
Step 3
Connect the included Ethernet cable to the LAN port on your
DHP-W220AV and to your computer's port. You may also connect
to the DHP-W220AV over Wi-Fi with the information on the Wireless
Configuration Card to proceed to set up your wireless network.
ROOM C
iPad
DHP-W220AV
Notebook
iPad
Notebook
3

Publicidad

loading