Installation Procedure - IntesisHome TO-RC-WIFI-1 Guia De Instalacion

IntesisHome TO-RC-WIFI-1
®

2. Installation procedure

Installation process should only be performed by an authorized
installer.
Please follow all safety Instructions provided by the toshiba service manual and/or installation manual.
there are two installation options available: With Control Panel and without Control Panel.
2.1 With Control Panel (Recommended)
this method assumes that you want to control the toshiba system both with IntesisHome and the
toshiba Control Panel.
1. Unplug the toshiba system from mains electricity.
2. open the top lid of the IntesisHome device.
3. Remove IntesisHome's top Hole cover.
4. Connect one end of toshiba's bus cable into IntesisHome device K1 connector.
5. Connect the other end of toshiba's bus cable into toshiba's Indoor Unit AB connector or Remote Control
Wiring (see www.intesishome.com/docs/to-RC-WIFI-1-Install_sketch.pdf for more information).
6. Connect another cable from toshiba's Control Panel connector to toshiba's Indoor Unit AB connector
or Remote Control Wiring (see www.intesishome.com/docs/to-RC-WIFI-1-Install_sketch.pdf for more
information).
Wi-Fi Router or
Access Point
4
3 m
K1
InstALLAtIon GUIDe
A
# 1
B
. . .
A
# n
B