Rain Bird GSV Instrucciones De Instalación Y Operación página 2

English
Refer to
F1
1. Flush main line thoroughly before installing valve.
2. Install valve onto main line. Ensure inlet side
is connected to lateral line. Note: arrow on valve indicating direction of water flow.
B
Solenoid should be on the downstream side of the valve.
C
3. Use 2-3 wraps of Teflon Tape along the full length of the inlet and outlet pipe threads. Do
not use pipe thread or pipe dope compound. Thread inlet pipe and fitting into the inlet
port of the valve and hand tighten. Thread outlet pipe and fitting into the outlet port of the
valve and hand tighten. Do not exceed two full turns beyond hand tight. Do not use tools
to tighten.
4. Connect one solenoid wire
ler power wire. Use only direct-bury wire connectors (Rain Bird WC-100) to complete water
resistant splice.
5. After installing valves, slowly open water supply at point of connection. Valves may dis-
charge water momentarily, and then shut off. Note: Opening water supply too quickly may
cause damage to equipment or personal harm.
6. To activate the valve using the external manual bleed feature, turn the bleed screw
on the top of the valve counter clockwise. Water will leak externally into the valve box to
relieve bonnet pressure and open the valve. Turn the bleed screw clockwise and the valve
will shut off once pressure builds in the bonnet.
7. For automatic valve operation, utilize the controller that has been wired to the valve
according to the controller operating instructions, or the central control.
8. Use the flow control handle
Turning counter clockwise will increase flow; clockwise decreases flow. Close the valve be-
fore making large flow adjustments, then activate the valve to fine tune flow adjustments.
Good adjustment practice, when not intentionally trying to limit the flow, is to turn the
flow control stem (from the full open position) clockwise until resistance is felt on the flow
control stem handle.
9. The Rain Bird pressure regulating module PRS-D
10. If the water supply is using treated water, please replace the flow control handle with the
supplied purple version (for plastic valves) or attach the purple cap on the flow control
handle (for brass valves) that you can find in the shipping box.
3
GSV (Plastic and Brass) Valve Installation & Operation Instructions
GSV (Plastic and Brass) Valve
Installation & Operation Instructions
to the controller common wire and the other to the control-
D
to adjust the amount of water flowing through the valve.
F
is connected to main line and outlet side
A
has already been installed to the valve.
G
E