Ordering Replacement Parts; Disposal And Recycling - EINHELL 45.004.80 Manual De Instrucciones

GB
Low (L)
Core sound insulation (SNR)
5. Assembly
See Fig. 3a-3f
6. Adjustments
6.1 Neck strap
The safety helmet can be adjusted to the
circumference of your head by turning the neck strap
adjuster (Fig. 2 / Item 5). Turning it clockwise will
reduce the circumference, turning it anti-clockwise
will increase the circumference. Only use the helmet
after it has been adjusted correctly.
To achieve the correct adjustment of the safety
helmet at maximum circumference, place it on your
head so that the 4-point strap (Fig. 2 / Item 6) is taut
on your head. Turn the neck strap adjuster clockwise
to tension the neck strap until the helmet sits
securely on your head without causing pressure.
6.2 Ear protection
The height and position of the ear protectors can be
adjusted. The height can be adjusted by sliding the
ear protection capsules (Fig. 4a). Their position can
be changed by turning them (Fig. 4b). To make it
easier to put the helmet on and take it off, the ear
protectors can be moved out of the way. If the
tension weakens, it can be adjusted by sliding the
ear protector adjuster (Fig. 4c/Item 4) towards the "+"
sign. The tension will be reduced if it is moved
towards the "-" sign.
6.3 Visor
The distance between your face and the visor can be
adjusted by moving the visor in the visor mounting as
shown in Fig. 5. If necessary the visor can be moved
out of the way by pulling it upwards.
7. Cleaning, storage and ordering of
spare parts
7.1 Cleaning
Clean the helmet at regular intervals using
lukewarm water and a little lubricant soap. Do
not use cleaning agents or solvents; these may
be aggressive to the plastic.
For regular cleaning and disinfection of the ear
protectors you can pull the insulating pads out of
the capsules and rinse them in lukewarm water.
8
= 14 dB The sealing rings can also be removed. They are
= 25 dB clipped to the ear protection capsules and can
simply be pulled off downwards.
Clean the visor at regular intervals using
lukewarm water and a little lubricant soap or
blow it out with compressed air.
7.2 Storage
Do not store the helmet in extremely hot
environments where it may be exposed to UV
radiation. This may reduce the service life of the
plastic. Store the helmet in a cool dark place
when it is not in use.
When the helmet is in storage, keep the ear
protectors in working position and make sure that
the sealing rings are not squashed. If the sealing
rings are under permanent strain, this will reduce
their effectiveness.

7.3 Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.