Leveling The Washer; Installation Of Non-Skid Pads (Optional) - LG STEAM WASHER WDT1652BDS Instrucciones De Instalación

I N S TA L L AT I O N I N S T R U C T I O N S

LEVELINg THE wASHER

The drum of your new washer spins at very high speeds,
up to 1,320 RPM. To minimize vibration, noise, and
unwanted movement, the floor must be a perfectly level,
solid surface.
NOTE: Adjust the leveling feet only as far as necessary
to level the washer. Extending the leveling feet more
than necessary can cause the washer to vibrate.
Leveling
Feet
Position the washer in the final location, taking
1
special care to not pinch, strain, or crush the
water and drain lines. Place a level across the top
of the washer.
Raise
Loosen the locknuts on all 4 leveling feet until you
2
can turn the feet with the included wrench. Turn
clockwise to raise the washer or counterclockwise
to lower it.
NOTE:
1. Transparent protection films are being attached to top plate,
side cabinet and front cover.
You could remove the films if you want.
2. Please keep the label attached on the top plate
(CIC Telephone number label, Steam caution label)
3. Using the leg stoppers is optional Without the pedestal, insert
the leg stoppers to the legs of the washer With the pedestal,
please insert the leg stoppers to the legs of the pedestal

INSTALLATION OF NON-SkID PADS (OPTIONAL)

Some floor surfaces are too slippery to prevent
the washer from moving on the floor during heavily
unbalanced loads. While it is normal for an occasional
load to be out of balance, excess noise and vibration
can result from the washer moving out of position.
If these conditions are encountered, follow the
instructions below for installation of the non-skid
pads. These pads will help prevent the washer from
moving during heavy out of balance conditions thereby
reducing noise and vibration.
14
• All four leveling feet must rest solidly on the fl oor. Rock
the washer gently from corner to corner to make sure
that the washer does not rock.
If you are installing the washer on the optional pedestal,
you must use the leveling feet on the pedestal to level
the washer. The washer's leveling feet should be fully
retracted and locked into position with the locknuts.
Level
Leveling Feet
3
Lower
Once the washer is level from side to side and
front to back, tighten all locknuts securely.
Make sure that all 4 leveling feet are in firm
contact with the floor.
NOTE: To make sure that the washer is properly
level, run the washer with a test load: place
approximately 6 pounds of laundry in the
machine. Then press POWER, press RINSE+SPIN,
and then press the START/PAUSE button. See the
following sections for additional information on
cycle selection and operation.
Verify that the washer does not rock or vibrate
excessively during the spin cycle.
If the washer vibrates or shakes, adjust the
leveling feet until the washer is stable and retest.
• Non-skid pads
This side up
Stick adhesive side to floor
Remove backing
✻ Place the pads under both front feet.
Tighten all 4
locknuts securely