Blaupunkt BP2913LK Manual De Instrucciones página 13

Materials You Can Cut
This jigsaw is a versatile tool that allows you to cut many different types of materials. Some of these materials include:
• Wood products such as lumber, hardwood, plywood, composite board, and panelling
• Drywall
• Fibre board and plastic
• Metals such as pipe, steel rods, sheet steel, aluminium, brass and copper.
NOTE: There are many different types of blades available. Generally, there are metal cutting blades (fine teeth) and wood cutting
blades (coarse teeth). Use the correct blade for your application. The packaging on the blade will indicate the type of materials each
blade is designed to cut.
General Cutting
Clearly mark the workpiece to locate the position of the cut.
Hold smaller workpieces with a vice. Clamp larger workpieces to a workbench or table.
WARNING Any workpiece that is not adequately clamped in place may come loose and cause serious injury. Never hold the
workpiece with your hand.
WARNING Keep hands and fingers away from between the motor housing and blade holder. Do not reach underneath workpiece
while jigsaw is running.
• Rest the front of the jigsaw base on the workpiece and align cutting edge of the blade with the cutting line on your
• workpiece Make sure the power cord is out of your way and not in the path the blade will follow.
• While firmly gripping the jigsaw, and with the blade NOT in contact with the surface to be cut, start the jigsaw by pressing the
lock-off button and squeezing the trigger switch.
• Once the jigsaw has reached the desired speed, gradually bring the moving blade into contact with the workpiece at the
appropriate location.
NOTE: Do not force the jigsaw. Use only enough force to keep the blade cutting. Excessive pressure on the blade will cause it to
bend and twist, which may result in breaking the blade.
Metal Cutting
Many types of metal can be cut with your jigsaw. When cutting any kind of material, be careful not to twist or bend the blades. Do
not force the blade. If the blade vibrates excessively, use a finer toothed blade. If the blade heats excessively, reduce the speed of
cutting.
Clamp all work firmly and jigsaw as close as possible to the clamping point to eliminate any vibration of the work being cut.
When cutting conduit, pipe or angle iron, clamp work in a vice if possible and saw close to the vice. To cut thin sheet materials place
the material between hardboard or plywood and clamp the layers to eliminate material vibration and tearing. By doing this, the
material will be cut smoothly. Lay out your pattern or cutting lines on top of the 'sandwich' .
Product Speci cations
Voltage
Power
Variable Speed
Bevel Angle
Orbital Positions
Stroke Length
Maximum Material Thickness
Dust Extraction
Weight
230-240V
750W
800 – 3000 SPM
0 - 45°
3
18mm
100mm Wood, 8mm Steel
Yes
2.3Kg