Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: Unplug the vacuum cleaner before performing any of these steps.
1. Remove the wand from the wand / hose holder as shown on
page
2. Squeeze the tabs on both sides of the quick clean-out port
and pull away from the vacuum (Fig. 22).
3. Check above and below the port opening for obstructions.
4. Remove any obstructions.
5. Replace the quick clean-out port by squeezing both tabs and
pushing it back into the wand / hose holder.
CAUTION: Unplug the vacuum cleaner before performing any of these steps.
Your Tornado vacuum cleaner comes equipped with a Manual Reset Thermal Fuse Protector. This thermal protector is
designed to protect your vacuum cleaner from overheating due to a cutoff in airflow (i.e. clogged hose, operating the
vacuum without a bag). Should this situation occur, the thermal fuse protector will safely shut off your vacuum to avoid
and potential damage.
To reset the thermal fuse
1. Unplug the vacuum cleaner.
2. Check for problem (over-filled bag, clog in hose, clogged filters, etc.).
3. Correct problem.
4. Locate 'tripped' fuse the small red button located on the bottom of
the back side of the main body roughly one inch to the right of the
left wheel. (Fig. 23).
5. Using a pointed object, push the reset button.
6. Plug vacuum cleaner in and begin using.
Keep machine and all accessories clean and in good operating condition.
Change vacuum bags and filters as recommend to maintain optimum cleaning efficiency.
Always use genuine bags, filters and parts, as use of other products may result in poor cleaning or filtration
performance. Tornado filtration products are designed for maximum performance.
Have machine checked periodically by the retailer where you purchased your Tornado vacuum.
Store machine carefully in dry area.
For optimum cleaning performance and safety, follow your owner's manual.
How to Clean the Brush Head Hose
Thermal Fuse Protection
For Best Performance
9
Fig. 22
Fig. 23
Publicidad
Capítulos
Tabla de contenido
