Disposal Information; Conformity; Exemption From Liability; Warning - Flex BME 18.0-EC + LK 152 Instrucciones De Funcionamiento Originales

Gear
NOTE
Do not loosen the screws on the gear head
during the warranty period. Failure to comply
with this requirement will invalidate any
claims under the manufacturer's warranty.
Repairs
Repairs may only be carried out by an au-
thorised customer service centre.
Replacement of wear parts
The felt pad on the swing arm is subject to
wear during operation of the belt sanding at-
tachment. Spare parts can be obtained from
the manufacturer or dealer.
Spare parts and accessories
Other accessories can be found in
the manufacturer's catalogues. Exploded
drawings and spare-part lists can be found
on our homepage: www.flex-tools.com

Disposal information

WARNING!

End-of-life power tools must be rendered
inoperable before disposal.
For mains-operated power tools, remove
–
the mains cable.
For battery-operated power tools, remove
–
the battery.
EU countries only
Do not dispose of electric power tools
in the household waste!
In accordance with the European directive
2012/19/EU on Waste Electrical and Elec-
40
TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
tronic Equipment and its incorporation into
national law, end-of-life electric power tools
must be collected separately and recycled
in an environmentally-friendly manner.
Recycling raw materials instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally-friendly
manner. Plastic parts are identified for recy-
cling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open end-of-life
batteries.
EU countries only: defective
or end-of-life batteries must be recycled in
accordance with directive 2006/66/EC.
NOTE
Please ask your dealer about disposal
options.

conformity

We hereby declare that the product described
under Technical data complies with the follow-
ing standards or normative documents:
EN 60745 / EN 62841 according to the
provisions of directives 2014/30/EU,
2006/42/EC, 2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Peter Lameli
Technical Head
15.12.2020
FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr

Exemption from liability

The manufacturer and its agent are not liable
for any damage and lost profit due to interrup-
tion in business caused by the product or by an
unusable product.The manufacturer and its
agent are not liable for any damage which was
caused by improper use of the power tool or by
use of the power tool with products from other
manufacturers.
Klaus Peter Weinper
Head of Quality
Department (QD)