Troubleshooting - Sage Tea Maker Guía Rápida

Troubleshooting

PROBLEM
Tea Maker will
™
not switch 'ON'
The Tea Maker
™
will not work
The LCD light has
gone out
?
I cannot select a
certain function
The LCD screen
displays 'RESET'
The LCD screen
displays 'ERROR'
POSSIBLE CAUSE
• Check the power plug is securely inserted into the outlet.
• Insert the power plug into an independent outlet.
• Insert the power plug into a different outlet.
• Reset the circuit breaker if necessary.
• For additional safety the Tea Maker
In the event of severe overheating, the Tea Maker
shut down to prevent further damage. Should this continue,
visit Sage Customer Service at sageappliances.com.
• Check the glass jug is securely positioned on the power base.
• The Tea Maker goes into standby mode if not used for 3 minutes.
™
• To re-activate the Tea Maker
- Remove then replace the glass jug from the power base.
- Press any button on the power base except the HOT WATER / Cancel
or TEA / Cancel buttons. The LCD screen will re-illuminate.
• Certain features cannot be selected or changed during the heating
or brewing cycle. The LCD screen may temporarily change or a sound
alert may be heard, but no changes to the cycle will be made.
• The LCD screen will display a flashing 'RESET' when there is a resettable
electronic issue. Remove the plug from the wall outlet, wait 5 seconds,
then plug back in.
• Visit Sage Customer Service at sageappliances.com if the 'RESET'
message continues.
• The LCD screen will display a flashing 'ERROR' when there
is a non-resettable issue with the appliance. Should this occur,
visit the Sage Customer Service at sageappliances.com
is fitted with a thermal cut out.
™
™
out of standby mode:
™
will automatically
13
EN