Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Installation
CONTROL MODULE
Use the template provided on page 7 to mark holes for
1
mounting screws. Drill one 40 mm in the center and two
10 mm holes for the mounting screws.
CAUTION
Verify the scale of the template if not using the installa-
tion guide shipped with the downdraft.
Check countertop thickness to make sure threaded
2
studs are long enough to allow thumbnuts to fully
engage. Thicker countertops may require the countertop
be countersunk from below.
Place the control module on the countertop then secure
3
using the two nuts provided. Once secure, install the
ground wire and nut.
Use provided cable or cable designated by local codes.
4
Connect one end of the control cable to back side of
control module and other to electrical connection on
front of downdraft assembly. Ensure all connections are
tight.
WARNING
Do not connect to telecommunication network.
GROUND
CONTROL MODULE
RJ45
CONNECTOR
NUT
RJ45
GROUND
CONNECTOR
COUNTERTOP
Downdraft connection.
Control module connection.
6 | English
TOP COVER
Insert the downdraft plug into a grounded (earthed) recep-
tacle, then check operation. Once operation is verified, raise
the chimney and install the top trim using the three nuts
provided. Verify the top trim is properly aligned with the side
covers. Refer to the illustration below.
FILTERS
Install the filters. Refer to the illustration below.
TOP COVER
Top cover installation.
Filter installation.
Troubleshooting
IMPORTANT NOTE:
If the downdraft ventilation system does
not operate properly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the downdraft.
•
Verify proper electrical connections.
•
If the downdraft does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
downdraft. Wolf is not responsible for service required to
correct a faulty installation.
Publicidad
