Fitting/Removing The Controller; Using For The First Time; Software Updates To The Controller; Starting Up The Controller - VULCANO Control Connect Manual De Instalación Y De Funcionamiento

Installation
4.5

Fitting/Removing the controller

Fitting
2.
Fig. 6 Fitting the controller
Removing
2.
1.
Fig. 7 Removing the controller
4.6

Using for the first time

4.6.1 Software updates to the controller

The software is updated automatically, over your internet
connection. Straight out of the box the controller may not have
the latest software installed, as a result, the full app
functionality may not yet be supported. The installed software
version can be checked on the cleaning screen ( section 7.1,
page 31).
28
1. 1.
1.
6720810446-30.1Wo
6 720 804 655-006.0N

4.6.2 Starting up the controller

▶ Turn on the boiler, this provides power to the controller.
▶ Remove the plastic screen protector.
The controller and boiler will link automatically:
• During the connection phase, the boiler, Wi-Fi and internet
connection icons are present.
• The controller establishes a connection with the boiler
(shown by a check mark [2] next to the boiler connection
icon [1]).
02.13.00
1
Fig. 8 Connection with the boiler
• The connection has been made with the boiler.

4.6.3 Connecting to the Wi-Fi network and internet

The controller can only connect to "visible"
networks. If the network that the controller has
to connect to is a "hidden network", this will
have to be made "visible". After connection is
made, the relevant network may be "hidden"
again.
• Once connected to the boiler, the controller will
automatically look for Wi-Fi networks [1].
• The Wi-Fi networks possibilities are displayed [2].
1
Fig. 9 Selecting Wi-Fi network
The display [2] shows the Wi-Fi networks found.
Control Connect – 6720818270 (2016/02)
2
02.13.00
2 3
Networkname 123
Networkname 123
Networkname 123
6
5 4