ASROCK ConRoeXFire-eSATA2 Manual De Instrucciones página 34

After the installation of Windows
to manage RAID functions, you are allowed to use both "RAID Installation Guide" and "Intel
Matrix Storage Manager Information" for RAID configuration. Please refer to the document
in the Support CD, "Guide to SATA Hard Disks Installation and RAID Configuration", which
is located in the folder at the following path: .. \ RAID Installation Guide and the document
in the support CD, "Guide to Intel Matrix Storage Manager", which is located in the folder at
the following path: .. \ Intel Matrix Storage Manager Information
If you want to use "Intel Matrix Storage Manager" in Windows
please install SATA / SATAII drivers from the Support CD again so that "Intel
Matrix Storage Manager" will be installed to your system as well.
2.15.2 2.15.2 2.15.2 2.15.2 2.15.2 Setting Up a "RAID Ready" System Setting Up a "RAID Ready" System Setting Up a "RAID Ready" System Setting Up a "RAID Ready" System Setting Up a "RAID Ready" System
You can also set up a "RAID Ready" system with a single SATA / SATAII hard disk.
A "RAID Ready" system can be seamlessly upgraded to RAID 0, RAID 1 or RAID 5
at a later date by using RAID migration feature of Intel Matrix Storage. The
following steps outline how to build an Intel "RAID Ready" system.
1. Assemble the system and attach a single SATA / SATAII hard drive.
2. Set up system BIOS as step 1 of page 33. When done, exit Setup.
3. Make a SATA / SATAII driver diskette as step 2 of page 33. Begin Windows
setup by booting from the installation CD.
4. At the beginning of Windows
driver. When prompted, insert the SATA / SATAII driver diskette containing the
Intel ® RAID driver. After reading the floppy disk, the driver will be presented.
Select the driver to install according to the mode you choose and the OS you
install. You may select: "Intel(R) 82801GR/GH SATA RAID Controller (Desktop
ICH7R-Windows XP/2000)" for Windows
SATA RAID Controller (Desktop ICH7R-Windows XP64)" for Windows
5. Finish the Windows
6. Install the Intel(R) Matrix Storage Manager software via the CD-ROM included
with your motherboard or after downloading it from the Internet. This will add
the Intel(R) Matrix Storage Console which can be used to manage the RAID
configuration.
7. After setting up a "RAID Ready" system as the above steps, you can follow the
procedures of the next section to migrate the system to RAID 0, RAID 1 or RAID
5.
3 4 3 4 3 4
3 4 3 4
ASRock ConRoeXFire-eSATA2 Motherboard
® 2000 / Windows ® XP / Windows
® setup, press F6 to install a third-party RAID
® XP/2000 or "Intel(R) 82801GR/GH
® installation and install all necessary drivers.
® XP-64bit OS, if you want
® environment,
®
® XP 64-bit.