GBC PUNCH G2 Manual De Instrucciones página 8

Changing the Settings on the LCD panel
1. Backgage Depth Setting
Backgage is the distance of the punched hole(s) from the trail
edge of the sheet. This distance can be adjusted by entering the
Settings section (press Up or Down from the Home screen, and
press OK for Settings).
Pressing Up arrow will increase the Depth of Backgage, and
Pressing Down arrow will decrease the Depth of Backgage.
"-" ON THE LCD
DECREASES
BACKGAGE
DEPTH
The settings for backgage MID L and MID XL adjust the backgage of
the double punch mode. MID L and MID XL function the same as the
regular backgage depth, but adjust the position of the middle punch.
MID L adjusts backgage for SEF letter and SEF A4, while MID XL
adjusts backgage for SEF 11x17 and A3
"-" ON THE LCD
DECREASES
BACKGAGE
DEPTH
2. Alignment Setting
Alignment is the distance of the Top punched hole from the side
edge of the sheet (viewed from the punch output orientation). This
distance can be adjusted by entering the Settings section (press
Up or Down arrow from the Home screen, and press OK for
Settings). Pressing Up arrow will increase the Alignment position,
and Pressing Down arrow will decrease the Alignment position.
BACKGAGE
"+" ON THE LCD
INCREASES
BACKGAGE
DEPTH
BACKGAGE
"+" ON THE LCD
INCREASES
BACKGAGE
DEPTH
"+" ON THE LCD
INCREASES
ALIGNMENT
OFFSET
ALIGNMENT
"-" ON THE LCD
DECREASES
ALIGNMENT
OFFSET
3. Clear Cover
Use this setting to adjust the Backgage depth and Alignment
setting for Clear Cover media. Adjusting this offset does not affect
the Backgage and Alignment settings of other media types.
4. Language
The LCD panel can be configured to display one of the following
languages: English; Francais; Espanol; Deutsch or Italiano.
5. Units
The LCD panel can be configured to display units in MM or
Inches.
Displaying Information on the LCD Panel
1. Die type
This is type of die-set currently installed in the punch.
2. Die cycles
This is the total number of sheets punched with the currently
installed die-set.
3. Punch cycles
This is the total number of punched sheets the system has
processed.
4. Firmware
This displays the current level of firmware of PUNCH G2.
PUNCH G2
EN
8