Electrical Connections 55-70-90-140 Pm/M-E - Lamborghini Caloreclima 55 PM/M-E Manual De Instalación Y Mantenimiento

ELECTRICAL CONNECTIONS 55-70-90-140 PM/M-E

The installation technician should perform connections to the mains, thermostat line (TA-TC-TS-TMF) and safety
light if present.
LEGEND
BRM Motor relay coil
CT Thermal relay contact
Connector seal check
C.CT
C.VE.PG Connector gas valve-gas pressure
Control electrode
EC
F Fuse
FA Anti-interference filter
IG Main switch
Ima ON/OFF switch
LP Lamp presence flame
LF Lamp operation
Lock-out warning light
LR
Lock-out warning light (option)
LR1
Burner motor
MB
If operating with a three-phase 220/230 V power supply without neutral, a connection jumper must be made between terminals
L3 and N of MR.
If operating with TMF, it is necessary to remove the connection jumper between terminals 1 and 4 of the MR terminal board.
When operating with CONTINUOUS MODULATION using a LANDIS RWF 40 regulator, remove the connection jumper between
terminal 9 - 7 of MR.
N.B. The connection from probe S to terminal G of MRM is required only with the pressure probe (LANDIS QBE...)
DO not exchange the neutral with the phase wire. Make proper earth connections..
COMPLY WITH GOOD ENGINEERING PRACTICES AND OBSERVE THE REGULATIONS IN FORCE.
Gradual two-stage operation
Continuous modulation operation
Two-stage operation modulation
MMS LANDIS SQN... servo control terminal board
MPE LANDIS LFL control box terminal board
MR Electric panel terminal board
MRM LANDIS RWF 40 - Modulation regulator terminal board
PA Air pressure switch
Minimum gas pressure switch
PGm
Reset button
PS
Motor relay contacts
RM
RT Thermal relay
S Sensor
TC Boiler thermostat
Tmf 2nd stage modulation thermostat (option)
TR Ignition transformer
TS Safety thermostat
Gas valve
VE
59