Cleaning And Maintenance - BOMANN TSG 7402.1 Instrucciones De Servicio

Tabla de contenido

Idiomas disponibles

Forgot to add a dish?

WARNING:

Open the door very carefully during operation,

there is a risk of water squirting out.

Dishware can be added any time before detergent

has been dissolved or rinse water drained off.

 Press the Start/Pause button to stop the opera-

tion. Once the spray arms have stopped, you

can fully open the appliance door.

 Add forgotten dishware.

 Press the Start/Pause button, the operation will

continue after approx. 10 seconds.

At the end of program

CAUTION:

Allow the appliance to cool down a bit after the

program has ended, before you open it. This

avoids that steam escapes that causing long-term

damages to your furniture.

At the end of the rinse cycle will sound a series of

signals; then the unit goes into standby mode.

If no operation takes place within 15 minutes, the

device switches off automatically - energy-saving!

Turn off

 Turn off the appliance.

 Close the water supply, if necessary!

 Remove the dishes after cooling (see "Unload-

ing the dishwasher").

 Leave the appliance door slightly open until the

next rinse cycle to avoid odors.

 If the appliance is not in use for an extended

period, disconnect it from the power supply!

Unloading the dishwasher

CAUTION:

Let the dishware cool down for about 15 minutes

before unloading. Hot dishes are sensitive to

knocks.

NOTE:

At the end of program there could be still water

drops inside the appliance.

Open the appliance door and pull out the basket.

Energy saving tips

 Always try to operate the dishwasher when it is

fully loaded.

 Do not rinse the dishes in advance under running

water.

 Use for each type of load the most appropriate

rinse program.

 Do not perform a pre-rinse (depending on mod-

el), if not necessary.