Installing The Main Or Additional Intercom Panel - Philips WelcomeEye Comfort Guía De Instalación Rápida

instructions which can be downloaded at www.philips.com.
Warning: during this step, do not connect the power supply to the 230V AC

4. Installing the main or additional intercom panel

Warning: The product must not be connected to the power supply before wiring is complete.
1
4
DES 9900 VDP
5 3 1 0 0 6
1 2
1 2
1 2 3 4 5 6 7 8
1 2
DES 9900 VDP
CFI Extel
5 3 1 0 0 6
ZI de Fétan, 01600 Trévoux
FRANCE
20V 110mA
RFID 125kHz
IP44
7
1 - Remove the tamper-resistant screw from the intercom panel.
2 - Tip the intercom panel cover forward.
3 – The intercom's lens should be approximately 1.60m above the ground.
4 – Mark the locations.
5 - Drill.
6 - Use pegs adapted to the nature of the support (the screws supplied are suitable for
solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike
GB7
2
5
2 1
2
8
WelcomeEye Comfort / Compact / 08/17
3
6
1
9
1m60