Check The State Of Your Work Site; Remove Hazardous Substances; Maintenance Of The Main Unit; Tjep Rc20 Blade - TJEP RC20 Rod Cutter Manual De Funcionamiento E Instrucciones

Also, do not operate the TJEP RC20 Rod Cutter in very cold places or inside refrigerators
where the temperature is freezing or below.

Check The State of Your Work Site.

Before using the tool, check whether the state of the work site is as follows. Is the worksite
free of foreign objects, debris, water, ice, snow, powered electrical cables, and excessive
dust? Is the floor free of obstructions? Is their adequate ventilation? Is the worker properly
insulated from the ground. Follow the operation instructions and avoid prohibited items.

Remove Hazardous Substances.

Since the tool is an electric tool, it may spark and cause an explosion or a fire if operated
near gas cylinders, thinner, or explosive and other hazardous substances or in a place
filled with flammable gas, etc. Therefore, do not use the tool in places where such hazard-
ous substances are present.

Maintenance of the Main Unit

Always unplug the saw from the electric outlet before attempting any maintenance. Clean
the entire unit occasionally by removing dust, debris and oils. Occasionally remove the
flush cutting bottom plate; then remove any cutting chips that remain lodged in the area
the cutting blade rotated.
It is also recommended that the cutting blade be removed and inspect for any materials
that did not exit out the chip exhaust area. This should be done after 4-8 hours of use.
Most material cutting chips would normally exit out the chip exhaust area and into the bag.
It is recommended that the bag be emptied when it becomes 2/3 full of cut material.

TJEP RC20 blade

The blade for the TJEP RC20 Rod Cutter should be replaced when the blade is dull or
chipped and a noticeable increase in cutting time has occurred.
To change the blade, remove the 4 screws (pos. 1) that hold the Blade Cover to the Body
(4). Remove the cover (pos. 2) and unscrew the 4 bolts (pos. 3) holding the blade to the
Hub. The replacement blades that you purchase have new screws to be used when in-
stalling the new blade. Make sure that when you remove the blade you clean out the head
of any metal debris that has not escaped the tool.

General Operating Cautions

The following describe the general cautions on operating tool. Always observe the cau-
tions stated in each item.
16
! DANGER May cause an explosion or a fire. Ignoring this warning may
cause death or serious injury. Never use the tool in places filled with flam-
mable gas or near hazardous substances of high flammability.