Installation Instructions - Cadet The Perfectoe UC072 Guia Del Propietario

READ ALL
INSTRUCTIONS
AND SAFETY
INFORMATION
IMPORTANT!
It is extremely
important that
you verify the
electrical supply
wires are the same
voltage as the
heater (i.e. 120 volt
heater to 120 volt
power supply and
240 volt heater to
240 volt power
supply). If
replacing an
existing heater,
check the labels of
the old heater and
replace using the
same voltage.
Hooking a 240 volt
heater to a 120 volt
power supply will
drastically reduce
the heater's
output. Hooking a
120 volt heater to a
240 volt power
supply will destroy
the heater.
Connecting your
heater to an
incompatible power
supply will void the
warranty.
2
PLACEMENT: Read IMPORTANT INSTRUCTIONS for important safety requirements. For best results,
install heater beneath a cabinet in the toe kick area. Install the Perfectoe (Model UC) horizontally. Do
not install the UC heater in the floor. Headers and bracing are not necessary. Heater must be
installed per the directions indicated on the lid. See clearance requirements for additional placement
instructions. Install at least 6 inches from the inside corner and/or vertical adjacent surfaces.
CONTROLS: A thermostat is required. A Cadet electronic thermostat is recommended for ultimate
control and comfort. Optional single or double pole field mount thermostat kits are also available.
STEP 1 Turn the Electrical Power OFF
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and
lock or tag the panel board door to prevent
someone from turning on power while you are
working on the heater.
STEP 2 Determine Area of Installation
The UC Series heater REQUIRES A MINIMUM
distance of 6 inches from adjacent surfaces
(See Figure 1). However, Cadet RECOMMENDS
12 inches from all adjacent surfaces for longer
and cleaner performance. Heaters must be
spaced at least 3 feet apart.
For installation in an existing wall/cabinet, cut
a rough opening 14½ inches wide by 3½ inches
high. Opening must be 8½ inches deep and
6 inches from adjacent wall.
Figure 1
WARNING! Vinyl floor manufacturers warn
that some vinyl may discolor from temperatures
in excess of 110° F. See your vinyl floor
manufacturer for temperature specifications
for your vinyl floor covering.

Installation Instructions

Part One
STEP 3
For wall thermostat applications, route supply
wire from circuit breaker to thermostat to rough
opening. For models with an optional field mount
thermostat kit, route supply wire from circuit
breaker to rough opening. Allow enough wire to
extend 12 inches beyond the opening. Place heater
lid aside. Remove the knockout and attach the
supply wire with a strain relief connector, leaving
6 inches wire lead for later use (See Figure 2).
STEP 4
Connect the supply ground wire to the green
grounding screw provided (See Figure 2).
Connect each supply wire to one heater wire
with wire connectors. Note: All wire connections
must be made inside the heater.
Figure 2
STEP 5
Reinstall heater lid and attach using four
screws provided. Slide heater into opening.
Fasten heater to cabinet with screws (not
provided) going through the lower holes
located on the flanges. Fasten grill to heater
with screws provided going through the upper
holes located on the flanges.
STEP 6
Turn the electrical power back on at the
electrical panel board (circuit breaker or
fuse box).
Route Supply Wires
Connect Supply Wires
Mount the Heater
Turn the Electrical Power ON
STRAIN RELIEF
CONNECTOR