Siedle SBCMC 650-02 Manual De Producto página 8

English
Application
Camera 80 for Siedle Steel. Available
for the systems In-Home bus, Access
or as a system-free camera.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
1 In the case of video systems, the
following mounting situation must
be avoided at all costs:
• direct ajour light
• direct sunlight
• very bright image backgrounds
• highly reflective walls opposite the
camera
• lamps or direct light sources
Mounting
2 Recommended mounting height
appr. 1.60 m to centre camera.
3 Pick­up angle of the camera with
an angle of aperture of appr. 80°.
The angle of vision of the camera
module can be pre­adjusted hori­
zontally and vertically by around 30°
depending on the mounting situ­
ation.
4 Setting the pick­up angle
Unscrew the bus camera at the
mounting plate, tilt forward at the
top.
5 On the back of the camera,
release the centrally positioned
screw by screwing the Allen key one
turn to the left. Position the camera
eye using the Allen key to the
required viewing direction.
Fix the camera eye in the required
position by turning the screw. Do
not fasten the screw too tightly.
8
6 Pick­up angle of the camera with
an angle of aperture of appr. 65°.
7 Wiring diagram SVTMC 640-... at
the Siedle In­Home­Bus
8 Wiring diagram SVTMC 640-... at
the Access System
Terminal assignment
SBCMC 650-...
TaK In-Home bus
TbK camera branch
Ta In-Home bus
Tb
Vc Camera actuation
GND
b Power supply 12 V AC
c
SACM 670-...
V1 Video signal
V2 (two-wire FBAS)
V3 Camera supply
V4
V5 Actuation of video output
V6
SCMC 612-...
SVTMC 640-...
+M Supply voltage
-M 20–30 V DC
Vc Camera actuation
-
VKA Actuation of camera
distributor
A1 Potential-free contact
A1
b Power supply 12 V AC
c
coaxial connection
L/S L = lead, S = shield
Installation
Installation, commissioning and pro-
gramming are described in the rel-
evant system manual and enclosed
with the line rectifier/server.
Measurement points
9 The measurement points of the
functional units which are located
parallel to the terminals are acces­
sible when mounted. For measure­
ments, the test shaft cover must be
removed. After measuring, replace
the test shaft cover.
Servicing
Release the operating panel using
the enclosed mounting key and take
it off.
If a camera has to be exchanged,
this is unplugged at the terminal
block and replaced.