Fast & Fluid Management Hercules Manual Del Usuario página 14

FAST & FLUID MANAGEMENT srl
A Unit of Idex Corporation
ACCESS TO ELECTRICAL WIRING IS PERMITTED ONLY TO TRAINED PEOPLE.
DO NOT USE THE MACHINE IF BACK PANEL IS NOT ASSEMBLED.
Safety use of the machine
The manufacturer has used all measures and attentions projecting, drawing manufacturing , checking , installing , starting and
defining the procedures for using its products, to guarantee the highest possible level during a rational use of the supplied
system. The components are in conformity to the recent security rules. Updated security equipments are installed to assure the
maximum security level that it is available today.
When using the FAST Digital Hercules, the following safety regulations need to be observed:
The "user" is expected to follow all local safety regulations. If there is a contradiction in European regulations and local
regulations, the demands of the most severe legislation must be met.
The installation and the maintenance of the Digital Hercules have to be performed by a specialized technician
Service safety rules
1. To prevent any physical injuries all outside panels should always be in place on the Digital Hercules and properly secured.
2. Don't touch protections system as speed control and blocking security closing door.
3. Prior to any maintenance and inspection of the Digital Hercules: disconnect the power cord from the outlet mains. Make
sure that the Digital Hercules cannot be started unexpectedly.
4. Do not leave any tools inside in the Digital Hercules after maintenance.
5. Check that the environment where the machine is installed conforms to local regulations (a permit issued by the fire
marshall or by local autority may be necessary) and avoid dangerous concentration of paint cans around the equipment.
It's forbidden to stock inflammable materials or other materials inside the machine. It's forbidden to use free flames,
incandescent objects or equipments able to create sparks in the local where the machine is installed.
6. It is recommended to install a ventilation system to guarantee that the concentration of dangerous vapours around all
electrical components is less than 30%.
7. At the end of the work avoid to keep free cans inside the machine and avoid to keep the machine switched on if it isn't used.
8. If the machine is switched on but it isn't stirring inside it, there isn't residual energy because the inverter is switched off.
9. In the locations where the Digital Hercules is installed the prohibition symbols "no smoking" have to be present placed at 5
meters from the machine.
The equipment is constructed for the treatment of NOT EXPLOSIVE MATERIALS.
It 'is forbidden to use this machine with inflammable or explosive vapours.
In case an extension is needed, please make sure it is correctly dimensioned, according
One mixer only (therefore no other machinary) is to be connected to a single
Already damaged packaging may cause damage to the your machine.
During the maintenance follow the security rules and the procedure described in this paragraph.
The Digital Hercules is to be operated only by trained personnel. FAST & FLUID MANAGEMENT Srl shall not be liable for any
damage or injury caused by non – compliance with the "user"- and "safety" - regulations presented in this manual, or by
not taking the usual and accepted precautions in handling, operating or repairing, even if not expressly stated in this
This is also valid for damage and/or accidents as a result of changes made to the machine, that are implemented without
to the electrical absorption of the mixer
magnetothermic switch
Avoid to operate the Digital Hercules if it is not loaded with a can.
Never use a load with a weight over 35 Kg.
Don't switch-off the machine with the can inside.
Do not place any damaged packaging inside the Digital Hercules.
Following rupture during mixing may cause damage to the Digital Hercules
Running the Digital Hercules with damaged packaging is at User's risk.
prior notice to and approval by FAST & FLUID MANAGEMENT Srl.
1155383H-it,en,es,fr,de - 12/06/2008
WARNING!
manual.
14