To Turn Off Gas To Appliance - Cedar Ridge CRHQD250T Operación E Instalación Del Propietario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Note: If pilot does not stay lit, refer to

Troubleshooting, page 22. Also contact a

qualified service technician or gas supplier

for repairs. Until repairs are made, light

pilot with match. To light pilot with match,

see Manual Lighting Procedure.

7. Keep control knob pressed in for 30 sec-

onds after lighting pilot. After 30 seconds,

release control knob.

Note: If pilot goes out, repeat steps 3

through 7. This heater has a safety inter-

lock system. Wait one (1) minute before

lighting pilot again.

8. Turn control knob counterclockwise

to the desired heating level. The main

burner should light. Set control knob to

The thermostatic control used on this model differs from standard thermostats. Standard ther-

mostats simply turn the burner on and off. The thermostat used on this heater senses the room

temperature. At times the room may exceed the set temperature. If so, the burner will shut off.

The burner will cycle back on when room temperature drops below the set temperature. The

control knob can be set to any comfort level between Low (1) and HIGH (5).

Shutting Off Heater

Turn control knob clockwise

OFF position.

1. Remove 2 screws securing screen to

stove. Carefully lift and pull screen forward

to remove.

2. Follow steps 1 through 5 under Lighting

Instructions, page 17.

3. With control knob in PILOT position, strike

match, and hold near pilot. Press in control

knob; pilot should light.

OPERATION

THERMOSTAT CONTROL OPERATION