Mounting The Unit - Patriot PMX50 Manual De Instrucciones

This symbol on the product or its
packaging indicates that this product must
not be disposed of with other waste.
Instead, it is your responsibility to dispose
of your waste equipment by handing it
over to a designated collection point for
the recycling of waste electrical and
electronic equipment. The separate
collection and recycling of your waste
equipment at the time of disposal will help
conserve natural resources and ensure
that it is recycled in a manner that
protects human health and the
environment. For more information about
where you can drop off your waste
equipment for recycling, please contact
your local city recycling office or the dealer
from whom you purchased the product.
Installation
1 Connect the Fence ground terminal to a
separate ground system that is at least 33'
(10 m) away from other ground systems.
2 Connect the Fence output terminal to the
fence.
Indoors/Dry locations with mains/line
connector
2

Mounting the unit

The unit can be mounted directly onto a
suitable vertical support or wall material using
the two 3‛ (75 mm) nails and two washers
provided . Thread washers onto the nails. Space
the nails 3‛ (75 mm) apart (or one nail length).
Hammer in the nails, allowing them to protrude
by 3/8‛ (10 mm). Slide the unit onto the nails
with the washers inside the mounting slot.
Note:
If the unit is being mounted on a wall
made of concrete, brick, plasterboard or similar,
use screws instead of nails. Wall anchors or
plugs may also be required.
Operation
1 Plug the unit into the mains/line power
supply.
2 Turn on the mains/line power supply
switch.
The pulse indicator light flashes each time
the unit pulses.