Dremel 220 Manual De Instrucciones página 7

Ocultar thumbs Ver también para 220:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DM 2610921728 12-05E
6. Remove nose cap from rotary tool.
7. Insert the rotary tool into the press with
the shaft lock to the front. Clamp the tool
to the tool bracket by tightening the clamp
nut Figure 3).
NOTE: Model 398 mounts with shaft lock to
the back and cord to the right. Models 400
and 800 mount with shaft lock to the right.
NOTE: When clamping rotary tool in holder,
make sure tool is seated properly and vent
openings are not covered.
8. Twist the top tube counterclockwise to
loosen and enable the tube to be adjust-
ed up or down. After desired height is
achieved, turn tube clockwise to tighten it
(Figure 4).
NOTE: Tube should not be extended when
tool is being used in tool holder.
Insert the cord into the cord clips (Figure
2). Holder will keep cord away from the
work area. Make sure there is sufficient
slack to keep the cord from being pulled
taut when the full stoke of the press is
used.
9. The Depth Stop is used when you wish
to drill holes to a measured depth. A
scale on the press housing is provided
for your convenience.
Set the depth stop adjustment to the
desired depth and tighten depth stop
lock knob (Figure 5). Four set screws
are also provided on the depth gauge
and left side of the housing assembly
(See Figure 5). These screws allow for
micro adjustments to the drill press. Use
1.5mm allen wrench to make adjust-
ments. Be carefull not to overtighten set
screws.
10. The small and large Angle Lock knobs
are used to secure the tool either verti-
Height
Adjustment
Lever
Small Angle
Lock Knob
Set Screws
12/4/07
11:08 AM
Figure 5. Setting Depth and Height Adjustments
Page 7
Figure 4. Adjusting Tube Height
cally or at a 90° angle. Tool may be used
at a 15°, 30°, 45°, 60°, 75° or 90° angle
for sanding, polishing or wire wheel
application.
Loosen the large and small knobs and
rotate the tool, then securely tighten
both angle lock knobs.
11. The Height Adjustment Lever is used to
secure the press on the tube at the prop-
er height.
Loosen the lever and move the
press/tool assembly to the desired posi-
tion, then tighten the height adjustment
lever.
7
Turn tube counter-
clockwise to loosen,
adjust tube up or
down, turn tube clock-
wise to tighten.
NOTE: Tube should
not be extended when
tool is being used in
tool holder.
Large Angle
Lock Knob
Depth Stop
Adjustment
Lock Knob
Set Screws

Publicidad

Tabla de contenido
loading

Tabla de contenido