Cutting Hair - Silvercrest 7133016 Instrucciones De Utilización Y De Seguridad

Before first use / Use
times. Before using it for a first time as well as for the following 3 charging
processes, charge the hair and beard trimmer for 12 hours.
j
To charge the device, push the on / oFF switch
oFF position.
j
First insert the adapter cable into the port
clippers and then insert the adapter into a suitable socket (230 V ~ ).
j
The state-of-charge display (LED)
charging is in process. When the batteries have been fully
charged, the hair and beard clippers can be operated for
60 minutes without being connected to the mains supply.
j
Always completely discharge the rechargeable batteries before
recharging them in order to ensure they last a long time.
Use
Q
Tip: The hair to be cut should be clean and dry.
j
Comb your hair through carefully to remove any knots.
j
Place the hairdresser's cape or a cloth around the throat and neck
to prevent hair from dropping into the collar.

Cutting hair

Q
Tip: First cut the hair to a longer length than is required, then proceed
in stages until you achieve the desired length.
j
Fit the comb attachment
j
Push it over the guide grooves on the sides of the hair and beard
clippers.
68 GB/MT
7
shines red and indicates that
6
.
1
down to the
5
of the hair and beard