Mounting The Scroll Station To Plywood - Dremel 1800 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly
Mounting the Scroll Station
to Plywood
24"
An alternative method of securing your Scroll Station is to
fasten the Scroll Station base to a mounting board 18" x 24".
Any good grade of plywood with a 3/4" minimum thickness is
11-7/8"
recommended. Follow the instructions for MOUNTING THE
SCROLL STATION TO A BENCH, substituting the 18" x 24"
board for the workbench and using 1/4"-20 flat head screws
7-7/8"
15"
for the hex head bolts (Figure 7). Screws must be mounted
from underneath the plywood with washers and nuts on top.
NOTE: For proper stability, holes must be countersunk so
19-13/16"
screw heads are flush with the bottom surface of the sup-
porting board.
Figure 8. Plywood Mounting Template
Securely clamp board to workbench using two or more "C"
clamps.
13

Publicidad

Tabla de contenido
loading

Tabla de contenido