Operating And Safety Notes - Hammerbacher XMST Serie Manual De Instrucciones

7. Operating and safety notes Series: XMST
Observe the regulations in section 2 safety notes on page 5, particularly:
•
•
Leave the immediate vicinity of the frame if it begins to move spontaneously.
Under no circumstances should you try to operate the frame. Do not use the
frame until it has been successfully, completely and professionally repaired.
•
•
•
Discontinue use of the frame if safety risks occur, e.g. switches stop
functioning as they should.
Warning of a risk of crushing and shearing.
•
•
Warning of injury or damage:
•
•
•
Warning of injury or damage:
•
•
Caution voltage:
•
•
52 XMST
Do not leave children with the table frame without supervision. Children
are not able to assess the risks associated with this table frame. They
are in great danger of injuring themselves, perhaps even with fatal
Do not exceed the maximum time delay on the frame.
as computers, work materials or other have been placed on the work
surface.
Discontinue use of the frame if unusual events happen (e.g. loud noises,
smoke formation etc.).
Only have the frame repaired by an expert.
Do not use the frame until it has been successfully, completely and
professionally repaired.
At least 30mm for constant distances
At least 500mm for obstacles that are out of sight
Remove power cables and electrical devices from the socket.
Only hold the upper arm of the foot frame while transporting the table.
Devices or objects standing on the desk could tip over or fall down
Constant use will damage the motor controls on the operating panel.
Do not exceed the maximum duty cycle according to the information on
the type plate.
shock.
Only operate the voltage at the mains voltage shown on the type plate.
Do not allow any moisture or water to touch the controls or the power
cable.