Utility; Common Interface - M Vision ST-5 USB Manual De Instrucciones

MENU GUIDE
III. Options
III-5. Network
This section may help you to set up network
configurartion.
1. IP Setup
Select one from three kinds of options for
Network Setting.
a) Not Use
In this case, network is disabled.
b) Automatic
This is for user to use dynamic IP address service.
After Select Automatic, and just push Apply button,
Box will reboot by itself. Box will get a new IP from
router.
c) Manual
This is for user to use static IP address service Put in with
your IP address, Subnet mask and Gateway. And push Apply
button, then Box will reboot by itself.
2. SW upgrade
a) Please check first where you can download file
b) Push "Input URL" button if you want to change the address
then you can see Keypad Dialog box Type URL address
where you will be downloaded.
c) After thping your URL address, press "Upgrade" button
and follow showing message.
Attention : Don't turn off STB during upgrading procedure.
20
MENU GUIDE
VI.Utility
This section may help you to use USB, etc.
Select Utility in Main Page using ▲▼ and press OK.
∙ VI -1. System Information
∙ VI -2. USB
∙ VI -3. Common Interface
∙ VI -4. USB PVR
VI-1. System Information
This option help you to know the current S/W and
H/W version. Also provides you the product name.
1. Select System Information in Options using ▲▼and
pres OK.
2. Press EXIT to return to the previous menu.
VI-2 USB
The receiver is equipped with host.
1. Select USB in Utility with ▲▼ and press OK.
2. If you want to change mode(S/W Upgrade, BootLoader
Upgrade), press RED button on the RCU.
3. Select the file which you want to upgrade using
▲▼ and press OK.
4. After downloading the selected file, the receiver will
reboot automatically.
VI-3 Common Interface
The receiver is equipped with one slot of Common
Interface which have access to the scrambled the pay per
view services with various conditional access modules
and a valid smart card.
The programs that can be descrambled are determined
by the conditional access module and smart card that you
use.
1. Select Common Interface in utility with ▲▼ and press OK.
2. Common Interface displays on the screen.
(The phrase 'No Module' is indicated when the
conditional access module is not istalled)
3. Insert the conditional access module into Slot 1 or Slot 2.
4. The name of the Slot differs according to each inserted conditional access module.
5. Press EXIT to return to the previous menu or press MENU to go to current live channel.
21