Useful Information; Caractéristiques Techniques - Chicago Pneumatic CP8528 Manual Del Usuario

mance of the battery pack. Avoid extended exposure to heat
or sunshine (risk of overheating).
The contacts of chargers and battery packs must be kept
clean.
For an optimum life-time, the battery packs have to be fully
charged, after used. To obtain the longest possible battery
life remove the battery pack from the charger once it is fully
charged.
The battery pack has overload protection that protects it from
being overloaded and helps to ensure long life. Under ex-
treme stress the battery electronics switch off the product au-
tomatically. To restart, switch the product off and then on
again. If the product does not start up again, the battery pack
may have discharged completely. In this case it must be
recharged in the battery charger.
Disposal
• The disposal of this equipment must follow the legisla-
tion of the respective country.
• All damaged, badly worn or improperly functioning de-
vices MUST BE TAKEN OUT OF OPERATION.
• The disposal of this equipment must follow the legisla-
tion of the respective country.
• Repair only by technical maintenance staff.
Maintenance instructions
• Follow local country environmental regulations for
safe handling and disposal of all components.
• Maintenance and repair work must be carried out by
qualified personnel using only original spare parts. Con-
tact the manufacturer or your nearest authorised dealer
for advice on technical service or if you require spare
parts.
• Always ensure that the machine is disconnected from en-
ergy source to avoid accidental operation.
• Disassemble and inspect the tool every three 3 months if
the tool is used every day. Replace damaged or worn
parts.
• To keep downtime to a minimum, the following service
kit is recommended : Tune-up kit
• Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or de-
stroy plastic which could result in serious personal in-
jury.
• Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use.
Use clean clothes to remove dirt, dust, oil, grease, etc.
Symbols
Remove the battery pack before starting any
work on the machine.
Please read the instructions carefully before
starting the machine.
10
N
0

Useful information

Website
Log in to Chicago Pneumatic: www.cp.com.
You can find information concerning our products, acces-
sories, spare parts and published matters on our website.
Country of origin
Copyright
© Copyright 2018, CHICAGO PNEUMATIC Tool Co. LLC,
1815 Clubhouse Road, Rock Hill, SC 29730
All rights reserved. Any unauthorized use or copying of the
contents or part thereof is prohibited. This applies in particu-
lar to trademarks, model denominations, part numbers and
drawings. Use only authorized parts. Any damage or mal-
function caused by the use of unauthorised parts is not cov-
ered by Warranty or Product Liability.
Caractéristiques techniques
Données de l'outil
Vitesse libre (tr/min)
Carré d'entraînement (mm)
Couple de calage (ft.lb)
Couple de calage (Nm)
© Chicago Pneumatic - 8940172294
Cordless Hammer Drill
Do not dispose of electric tools together with
household waste material. Electric tools and
electronic equipment that have reached the end
of their life must be collected separately and re-
turned to an environmentally compatible recy-
cling facility. Check with your local authority or
retailer for recycling advice and collection
point.
European Conformity Mark
National mark of conformity Ukraine
EurAsian Conformity Mark.
Korean Conformity Mark
Always wear goggles when using the machine.
No load speed.
CAUTION! WARNING! DANGER!
Regulatory Compliance Mark (RCM), Product
meets applicable regulatory requirements.
CP8528
0 - 1500 rpm
10
24
34