Starting A Warm Engine; Starting A Flooded Engine; Stopping The Engine - Little Wonder 2300 Manual De Instrucciones

D. Starting a Warm Engine
1. Slide ignition switch to START position.
2. Push choke lever in to RUN (open) position.
3. If there is no fuel in the clear return line, push primer bulb
3-4 times or until fuel is visible in the line.
4. Pull starter rope using short pulls, 1/2 to 2/3 of the rope
length.
5. If engine fails to start in 4 pulls, use cold start procedure.
6. With both hands on the handles, squeeze throttle trigger
gradually to increase the engine speed and engage
the blades.
E. Starting a Flooded Engine
1. Remove the cap from the spark plug and unscrew the plug
with a spark plug wrench. If the end of the
spark plug is wet, the engine may be flooded.
2. Use a paper towel or clean rag to dry the end of the spark
plug.
3. Reinstall the spark plug and cap.
4. Push the choke lever to the run position and pull starter
rope three to four times.
5. Now push the choke lever to the closed position and pull
the starter rope until the engine sputters.
6. Finally, push the choke lever to the open position and pull
the starter rope to start the engine
8.
F. Stopping the Engine
1. Release the throttle trigger and allow engine to idle.
2. Slide ignition switch to the STOP position.
3. Make sure blades have come to a complete stop before
releasing either handle.
Start/ Stop Switch
Start/ Stop Switch
Throttle Trigger
WARNING
IF ENGINE DOES NOT STOP WHEN SWITCH IS PUT
IN THE STOP POSITION, RELEASE THE THROTTLE
TRIGGER, ALLOW ENGINE TO IDLE.
PUT THE TRIMMER DOWN, AND PUSH THE CHOKE
LEVER TO THE CLOSED POSITION.
Lockout Trigger
Fast
Slow
– DANGER