Technical Data; Charging The Battery; English | 11 - Bosch 1 270 020 500 Manual De Instrucciones

OBJ_BUCH-1392-001.book Page 11 Monday, January 17, 2011 2:51 PM

Technical Data

Lithium-ion battery
Article number
– Standard battery,
black
– Standard battery,
white
– Standard battery,
silver
– Rear rack battery
Rated voltage
Rated capacity
Energy
Operating temperature
Storage temperature
Allowable charging
temperature range
Weight
Degree of protection
Assembly
Place the battery only on clean surfaces. In
particular, avoid contaminating the charge
socket and the contacts, e.g. by means of
sand or ground.
Checking the Battery Before Using for
the First Time
Check the battery before charging it or using it
with your eBike for the first time.
For this, press the On/Off button 4 to switch on
the battery. When no LED of the charge-control
indicator 3 lights up, the battery may be dam-
aged.
Do not charge a damaged battery and do
not use it. Please refer to an authorised bi-
cycle dealer.
When at least one, but not all LEDs of the
charge-control indicator 3 is lit, then fully charge
the battery before using for the first time.
Bosch ebike Systems

Charging the Battery

Battery Pack
Note: The battery is supplied partially charged.
1 270 020 500
To ensure full battery capacity, completely
charge the battery in the charger before using
1 270 020 501
for the first time.
The battery must be removed from the eBike for
1 270 020 502
charging.
1 270 020 503
For charging the battery, read and observe the
V= 36
operating instructions of the battery charger.
Ah 8
The battery can be charged any time without re-
Wh 288
ducing the battery life. Interrupting the charging
procedure does not cause damage to the bat-
°C –10...+40
tery.
°C –10...+60
The battery is equipped with a temperature
control indicator, which enables charging only
°C 0...+40
within a temperature range between 0 °C and
kg 2.5
40 °C. This provides for a long life of the
battery.
IP 54 (dust and
splash water
Charge-control Indicator
protected)
When the battery is switched on, the five green
LEDs of the charge-control indicator 3 indicate
the charge condition of the battery.
In this, each LED indicates approx. 20 % capac-
ity. When the battery is completely charged, all
five LEDs light up.
Additionally, the charge condition of the
switched on battery is indicated on the drive
HMI. Read and observe the and operating in-
structions of the drive unit and the drive HMI.
When the capacity of the battery is below 5 %,
all LEDs of charge-control indicator 3 on the bat-
tery go out; however, the drive HMI does provide
an additional indication.
Use only the charger listed on the graphics
page. Only this charger is matched to the
lithium-ion battery used in your eBike.
0 275 007 40X | (17.1.11)

English | 11