AEM UV-C Manual De Instrucciones página 4

GB AEM UV-C MODULE 40W AMALGAM
WORKING
The AEM UV-C Module ensures crystal-clear water. The sophisticated design and high quality materials produce
high UV-C radiation with a wavelength of precisely 253.7nm. This high level of radiation kills almost all bacteria,
viruses and even fungi, providing clear and clean water. As a result, the level of added chemicals (eg chlorine) can be
reduced by up to 80%, which ensures more natural, healthier water!
The intelligent electronics indicates when the lamp is not producing enough radiation and needs to be
changed. Your device will always be working perfectly!
SAFETY AND INSTALLATION REQUIREMENTS
- See the Technical Specifications for the required voltage and current.
- The device may only be connected to an electrical installation that meets the legal requirements. A GFCI (30ma)
and earthed sockets are required. If in doubt always use a certified electrician to install.
- The electronics box and the plug must be positioned at least 2m from the tank.
- Always keep the plug free from moisture. Ensure that water cannot track down the power cord to the socket.
(See figure 1 for how to loop the power cord).
- Never submerge the device in liquid.
- The device can withstand a maximum pressure of 3 bar.
- The device is suitable for fresh and salt water.
- The device is designed to operate with a water temperature between 0 and 40 degrees C. Outside these
temperatures the device must be completely disconnected from the water.
- Before use, check the whole device, power cord and plug for damage. In case of any damage, the device must not
be used. Please let your dealer assess any damage.
- The device may only be connected if there is a sufficient flow of water.
- To avoid possible harm to eyes or skin, never look directly in to the UV-C lamp (the system will indicate if the lamp
needs to be changed).
- During maintenance, the device and pump must be disconnected from the mains. Be aware that the lamp can
remain hot for up to 10 minutes after being disconnected.
INSTALLATION OF THE DEVICE; SEE FIGURE 2
The electronics box (A) must remain visible so that the indicator that the UV-C lamp (B) needs changing can be seen.
Take into account accessibility for maintenance (see also Maintenance and disassembly).
1. Undo the lock nut (C) from the adapter (D).
2. Carefully unpack the UV-C lamp (B) and slide this into the quartz sleeve (E).
3. Put the UV-C lamp (B) into the lamp holder (F) and slide this further into the quartz sleeve (E).
Make sure that the O-rings (G1&G2) sitting properly.
4. Tighten the lock nut (C) hand-tight at the adapter (D).
4