Beta 1464T Manual De Instrucciones página 61

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
• When the tester is detected, the PC checks if there is a new firmware in Beta server and notifies the
user. See fig.4
• Press OK to start the updating process.
• Next message (see fig.5) will tell you to turn off the tester and then press the power button continuously
until the PC detects the tester. In this step is very important that you keep the power button
pressed (about 6 seconds) until the PC detects the tester in update mode(see fig.6).
• When the tester is detected the update process will begin (see fig.6).
• Wait until the update process finishes, the PC will show the message "Update finished" (see fig.7).
• Press "OK" and disconnect the tester.
• The update process is finished.
Fig.6
Fig.4
Fig.5
EN I
Fig.7
5