Trobuleshooting; Conformity With Directives - Hoover H-HOOD 300 DECOR Instalación Y Manual Del Usuario

Refit the hood glass and fasten the glass screws. Make sure the screws are
fully tightened.

TROBULESHOOTING

Fault
Light on, but
fan does not
work
Both light and
fan do not
work
Serious
Vibration of
the unit
Suction
performance
not good
CUSTOMER ASSISTANCE SERVICE
If you cannot identify the cause of the operating anomaly, switch off the
appliance and contact the Assistance Service.
PRODUCT SERIAL NUMBER. Where can I find it?
It is important you to inform the Assistance Service of your product code
and its serial number (a 16 character code which begins with the number 3);
this can be found on the guarantee certificate or on the data plate located
on the appliance.
It will help to avoid wasted journeys to technicians, thereby (and most
significantly) saving the corresponding callout charges.
42
Cause
The fan blade is
jammed.
The motor is damaged.
Halogen light bulb burn.
Power cord looses.
The fan blade is
damaged.
The fan motor is not
fixed tightly.
The unit is not hung
properly on the bracket.
Too long distance
between the unit and
the cooking plane
Solution
Switch off the unit and repair by
qualified service personnel only.
Replace the bulb with correct
rating.
Plug in to the power supply again.
Switch of the unit and repair by
qualified service personnel only.
Switch off the unit and repair by
qualified service personnel only.
Take down the unit and check
whether the bracket is in proper
location.
Readjust the distance to 65-75cm
74